Preventive maintenance and retrofit

Recurrent test and fault location

Measuring instead of disconnecting - Compliant expert solutions

Recurrent test and fault location

All electrical equipment must be tested on a regular basis. This is in the interests of the system operator. After all, tests prevent high repair costs and consequential damage as a result of poor maintenance. It is also the only way to guarantee optimum configuration of devices and systems. Bender offers solutions for measuring without disconnection.

Bender Service portal
Technical paper Electrical safety in control and auxiliary circuits

Recommended test systems:

Recommended systems for ground-fault location:

Analyzing and reporting:

IEC 60364-7-710
Electrical installations of buildings - Part 7-710: Requirements for special installations or locations - Medical locations

IEC 60947-6-1

Low-voltage switchgear and controlgear - Part 6-1: Multiple function equipment - Transfer switching equipment

Retrofitting

Does my system still meet the current requirements?

Retrofitting

Even with state-of-the-art electrical engineering equipment, time can take its toll. Whether it is a decline in operational reliability, changes in statutory regulations or increasing energy costs: adapting to the latest state of the art is crucial. Typically, products to monitor energy quality and for troubleshooting are retrofitted. Get us to test your electrical systems and we will give you suggestions as to how to proceed.

Brochure Bender Remote Assist
Application Note EDS309x
Technical paper Insulation fault location - Planning and set up in the solar charging station at the University of Applied Sciences Bingen
Technical paper Electrical safety in control and auxiliary circuits

Recommended test systems:

Recommended systems for ground-fault location:

Analyzing and reporting:

IEC 60364-7-710
Electrical installations of buildings - Part 7-710: Requirements for special installations or locations - Medical locations

IEC 60947-6-1

Low-voltage switchgear and controlgear - Part 6-1: Multiple function equipment - Transfer switching equipment